willemx2

Comments

• Allright getting closer here:  It's clear I need to flash the firware configuation.h to enable to make changes in the eeprom. Next thing for me is: I will try to flash this type of board...

  in Connect to repetier host: Yes, Recieve commands: No Comment by willemx2 November 2017
• I have a Anet V1.0 board: [img]https://ae01.alicdn.com/kf/HTB1WDJnQFXXXXbgXpXXq6xXFXXXn/2017-Updated-3D-Printer-Control-Motherboard-for-Anet-V1-0-Printer-Control-Reprap-Mendel-for-anet.jpg_640x640.jpg[/img]

  in Connect to repetier host: Yes, Recieve commands: No Comment by willemx2 November 2017
• Should I change the line in Configuration.h which controls whether or not EEPROM is enabled?

  in Connect to repetier host: Yes, Recieve commands: No Comment by willemx2 November 2017
• Ah ok clear: sending the code M92 X80 doesn't send it to eeprom, but to RAM... I thought with code M500 it would save the settings to EEPROM but I'm a bit confused now. How will I be able to read the number of steps and change it now? By the way I…

  in Connect to repetier host: Yes, Recieve commands: No Comment by willemx2 November 2017
• Great, thanks for the fast response! Ok so the firmware is: 21:16:48.733 : FIRMWARE_NAME:Repetier_  http://omni3d.1688.com/ PROTOCOL_VERSION:1.0 MACHINE_TYPE:Mendel EXTRUDER_COUNT:1 REPETIER_PROTOCOL:2 Everytime I send an M501 when it's printing I …

  in Connect to repetier host: Yes, Recieve commands: No Comment by willemx2 November 2017