tip32a
About
- Username
- tip32a
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
That worked. Thank you.. I can now change the perimeters. BUT FYI. The option for Printer settings was not there before I rebooted. Meaning for the last 7 days or so ever since upgrading repetier I have not rebooted. When I went to find the pr…
-
Thank you, I will try later this evening.
-
In my case I may be doing it wrong but I am opening Repetier, Loading the STL Slicing it and saving the file to a SD card. Bringing the SD card to the printer. The gcode is being generated BEFORE it is saved to the SD and that would be Repetier. …
-
Thank you for your reply, I am confused here. I am only using your software. Who knows the answer if not the writers?
-
Found the problem Cant locate the solution. This code is getting added to all new files. M201 X9000 Y9000 Z500 E10000 ; sets maximum accelerations, mm/sec^2M203 X500 Y500 Z12 E120 ; sets maximum feedrates, mm/secM204 P1500 R1500 T1500 ; sets acceler…
-
Below are my settings They look ok to me and the documentation I can find. Can you advise alternative settings. My printer has been down since I upgraded and I was printing COVID PPE... and prototypes.... /** * Default Axis Steps Per Unit (steps/…
-
But what changed from prev editions to this edition that now causes this. I do not want to go rewrite firmware