- Last Active
That worked. Thank you.. I can now change the perimeters. BUT FYI. The option for Printer settings was not there before I rebooted. Meaning for the last 7 days or so ever since upgrading repetier I have not rebooted. When I went to find the pr…
Thank you, I will try later this evening.
In my case I may be doing it wrong but I am opening Repetier, Loading the STL Slicing it and saving the file to a SD card. Bringing the SD card to the printer. The gcode is being generated BEFORE it is saved to the SD and that would be Repetier. …
Thank you for your reply, I am confused here. I am only using your software. Who knows the answer if not the writers?
Found the problem Cant locate the solution. This code is getting added to all new files. M201 X9000 Y9000 Z500 E10000 ; sets maximum accelerations, mm/sec^2M203 X500 Y500 Z12 E120 ; sets maximum feedrates, mm/secM204 P1500 R1500 T1500 ; sets acceler…
Below are my settings They look ok to me and the documentation I can find. Can you advise alternative settings. My printer has been down since I upgraded and I was printing COVID PPE... and prototypes.... /** * Default Axis Steps Per Unit (steps/…
But what changed from prev editions to this edition that now causes this. I do not want to go rewrite firmware