› ›

thibis

About

Username
thibis
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Hi, i upgrade the firmware to 1.0 and I have better results! =D First height map X: -50,00 -33,33 -16,67 0,00 16,67 33,33 50,00 y: 50,00 5,12 4,98 4,98 4,94 4,93 4,93 5,04 y: 33,33 4,93 4,90 4,91 4,91 4,89 4,89 4,90 y: 16,67 4,92 4,91 4,89 4,90 4,9…
    in G33 + height map - Delta Comment by thibis August 2018
  • First you know  #define Z_PROBE_Z_OFFSET 0.45means you have a 0.45 mm coating you do not want to consider? That is used normally only if you have inductive z probe and different bed coatings so it is easier to adjust No, I was thinking this is the Z…
    in G33 + height map - Delta Comment by thibis August 2018
  • Yes, It was z10, it reads 6.26mm. What I change? Z_probe_height or z_probe_bed_distance? If I send g1 Z10 and then g33, all the measures must be +-10mm? Thanks again! *edit Sorry for my bad English, is not my first langua…
    in G33 + height map - Delta Comment by thibis August 2018
  • Thanks for your reply. I test and my z=0 is OK. I send g1 z10, then g30 (the zprobes was 6.26) and it return to z10 *editing: when I press +0.01 it move more than 0.01
    in G33 + height map - Delta Comment by thibis August 2018