› ›

terzyans

About

Username
terzyans
Joined
Visits
6
Last Active
Roles
Member

Comments

  • Hi Repetier, Thanks for quick response and very good advise. I don't have Z-probe, and did not change anything in Z-probe settings. I tested your suggestions and they worked. I was afraid that if head will stay at Z=0 it will trigger the z-min end s…
    in problem with Z-homing Comment by terzyans September 2019
  • Thanks a lot for response. Meanwhile i could solve the problem with fan. I switched it to pin A9/D63. Initially I gave pin number 9 as analog numbering and it did not work. Later I gave it as pin 63 and it solved the problem. I decided to do the sam…
    in problems with second extruder. Comment by terzyans May 2018
  • Nobody had this problem. 
    in problems with second extruder. Comment by terzyans May 2018
  • Sorry for my previous post.  I typed the commands in separate lines, but after posting they all vere merged.            Simon
    in Extruder motor won't go Comment by terzyans March 2015
  • Hi guys,It seems to me that I solved this problem. In config file there is a lineEXT0_ENABLE_PIN E0_ENABLE_PINIt must be replaced with EXT0_ENABLE_PIN  ORIG_E0_ENABLE_PINIn my case it helpedSimon
    in Extruder motor won't go Comment by terzyans March 2015