terzyans
About
- Username
- terzyans
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Hi Repetier, Thanks for quick response and very good advise. I don't have Z-probe, and did not change anything in Z-probe settings. I tested your suggestions and they worked. I was afraid that if head will stay at Z=0 it will trigger the z-min end s…
-
Thanks a lot for response. Meanwhile i could solve the problem with fan. I switched it to pin A9/D63. Initially I gave pin number 9 as analog numbering and it did not work. Later I gave it as pin 63 and it solved the problem. I decided to do the sam…
-
Nobody had this problem.
-
Sorry for my previous post. I typed the commands in separate lines, but after posting they all vere merged. Simon
-
Hi guys,It seems to me that I solved this problem. In config file there is a lineEXT0_ENABLE_PIN E0_ENABLE_PINIt must be replaced with EXT0_ENABLE_PIN ORIG_E0_ENABLE_PINIn my case it helpedSimon