› ›

t0t0

About

Username
t0t0
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Thank you very much for your reply, computer science is not my field but I think I understand. If so, there is no point in continuing with other attempts. I hope more updates will come out soon that will correct this problem.Thank you again.
    in Repetier host dont send M600 when sensor is Open Comment by t0t0 September 2020
  • this is the firmware setting for FILAMENT_RUNOUT_SENSOR #define FILAMENT_RUNOUT_SENSOR #if ENABLED(FILAMENT_RUNOUT_SENSOR) #define NUM_RUNOUT_SENSORS   1 // Number of sensors, up to one per extruder. Define a FIL_RUNOUT#_PIN for each. #define FIL_R…
    in Repetier host dont send M600 when sensor is Open Comment by t0t0 September 2020