› ›

szivgy

About

Username
szivgy
Joined
Visits
22
Last Active
Roles
Member

Comments

  • I resolved the problem, It was a hardware problem, motor controlers overheated and turned off when cooled down turned on
    in moving problem Comment by szivgy February 2015
  • Unfortunately the problem exists both direction. I notice when the problem occur the motor don't get power (the motor don't hold), but after a few time the motor get power again
    in moving problem Comment by szivgy February 2015
  • Sorry for my poor English sometimes I mean not always but it is very frequent. All end stop are in low state in this situation. (End stop are in high state when switch)
    in go home problem Comment by szivgy February 2015
  • Than you for your answer. It was contact problem.
    in z axis motor back and forth Comment by szivgy February 2015