skutch
About
- Username
- skutch
- Joined
- Visits
- 47
- Last Active
- Roles
- Member
Comments
-
Thanks guys, I'll check 1.5.2 out today; I print a lot of stuff each run, so it should be a good test.
-
The preview shows everything perfectly normal, you only see the problem when it goes to print the brim on the second pad. Thanks, just sent the files over, check them out and let me know.
-
Best I can do without wasting more material to start printing the error. If I could upload a file, I'd send you the STL of the pad, then you could load it in, do a 1 part copy with auto placement and slice it to see the error.
-
From my understanding, RH launches slic3r when you click the Slice button, I don't know if the version that ships with RH is the unmodified program or if it was tweaked for RH, but something in the process of RH using it, generated the problem. The…
-
The thing is, there should not be any negative coordinates generated from the slice, the parts are in the center of the print bed with about 3 squares all around them, so the built in version of Slic3r is generating illegal negatives, but only for t…
-
So after some more checks, I found that when I place 2 individual pads with the same orientation, the problem occurs, but when I save the pads to a new STL and just load the single STL and slice, it doesn't create the issue. I also tried loading…
-
So after some more checks, I found that when I place 2 individual pads with the same orientation, the problem occurs, but when I save the pads to a new STL and just load the single STL and slice, it doesn't create the issue. I also tried loading th…
-
So I did some checking and it looks like the problem lies in these negative coordinates Slic3r generated: G1 X18.810 Y56.385 F9000.000 G1 X-0.308 Y55.498 F9000.000 G1 X-2.360 Y91.996 F9000.000 G1 X-0.859 Y110.495 F9000.000 G1 X57.716 Y138.226 F9000…
-
The weird part is that it is an L shaped pad; when I print them both in the same orientation, the problem occurs, when I print 1 normal and the other rotated 180 degrees, it works fine. I even tried downloading Slic3r directly from their website; i…
-
I just tried starting 2 smaller pads, about a 2" x 3" total area on the print bed, and they are processing fine, but the larger pads, about a 4" x 6" area messed up, even when I separated the pads into 2 distinct areas, not connected in any way.
-
Not totally sure it is slic3r though, because the preview in Repetier-Host shows the pads in the correct spots; which kind of suggests that RH is sending the wrong command out maybe?