rejaak
About
- Username
- rejaak
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
another FYI: just installed latest marlin 1.1bugfix version and bltouch issue is gone but the e-steps issue remains. when i ask for 100mm, it extrudes 63.2mm.
-
just an fyi, my bltouch keeps reseting about once per minute causing errors in host 2.0. this also happens with pronterface and cura so apparently its a problem with marlin 1.1
-
my setup is: migbot i3 with an mks gen 1.4 controller board using a toranado geared extruder at a 5:1 ratio. my e-steps are normally at 488.83. i followed your instructions and edited the xml for e-steps, e feedrate and e acceleration as none of th…
-
UPDATE: just found out that marlin 1.1 was released. downloaded it, configured and installed. now when i start repetier host 2.0, my bltouch keeps resetting about once a minute which for some reason reboots marlin and host comes up with an error eve…
-
i also am having this problem. i have 3 printers, one of which uses smoothieware, but the other 2 use marlin rc8. the e steps do not show up in the firmware config area and my printers under extrude terribly. i tried wiping the eeprom thru arduino 1…