reid60
About
- Username
- reid60
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Ohh yeah! To correct the distorsion values in configuration.h i used the repetier's configuration tool which is linked within the configuration file. I checked the distortion_correction_r and changed it to 90. After downloading only this file, i che…
-
Thank you, Roko. I'll try it tonight.
-
Roko said: If 0,0 is center on a delta, shouldn't x-min, y-min be negative? Ok, but why all other commands are working. Before trying leveling the printer i printed some parts (because z-probe has been defect). They haven't been perfect bu…
-
Ok, i did it from start: - checked configuration.h with repetier configuration tool on homepage - compiled it, uploaded it, M502, M500 - run home, centered extruder G131 - justified the sliders, M99 X0 ..., for all towers - measured and saved bed l…
-
I don't remember if i've done so. Ok, i will start from beginning and check this.
-
Sorry, radius not 200 but 100 :-)
-
These values are set correctly in my uploaded configuration.h. Do you think they are wrong? The maximin printer radius is 200. #define DISTORTION_CORRECTION 1 #define DISTORTION_CORRECTION_POINTS 5 #define DISTORTION_CORRECTION_R 90 #define DISTORT…
-
Ok, thanks. Can you tell me how they are named.