plasto
About
- Username
- plasto
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Thanks, do you have any tips on the slight tilt (Pisa tower)?
-
I reduced the speed from 200mm default to 150mm as advertised by HE3D manufacturer, and that seems to have helped. But still not straight line cube, a bit tilted and wider at the bottom: https://ibb.co/s2wVCdhhttps://ibb.co/6tg2dnMhttps://ibb.co/HY…
-
On closer inspection I found the missing switch, it just didn't come with the plastic board carrier like the other two. Thanks for the foil tip , but I have one other issue: the Y axis steps in the direction from rear Y motor towards the user in th…
-
plasto said: Sorry, I mentioned earlier, it seems I didn't receive the X sensor with the printer package. Should I manually home the X before each print (like a typewriter)? Also, what is the correct position of the printhead for starting my …
-
Sorry, I mentioned earlier, it seems I didn't receive the X sensor with the printer package. Should I manually home the X before each print (like a typewriter)? Also, what is the correct position of the printhead for starting my first print? I place…
-
Thanks for the tip, however it seems I have the Repetier firmware 0.9.1. I've managed to home the two axis for which I got the limit switches (Y and Z), however homing the X axis seems to end in pain until I hit the emergency button in the UI.
-
How to find out whether my firmware is supported? As I mentioned, I can move on all 3 axis. I'm a developer, but a complete newb when it comes to 3D printing. Can you point to a basic tutorial on software endstop configuration (as I only have one ha…