› ›

opy01

About

Username
opy01
Joined
Visits
38
Last Active
Roles
Member

Comments

  • Thanks for the reply.  I know during homing it sets a negative number looking for the endstop to be triggered, but this happens after the endstop is triggered.  I have the z-probe as the z min endstop so when z-probing is disabled the probe itself a…
    in New setup Z homing crashes into bed Comment by opy01 April 2018
  • I just noticed that when I home the z axis, I can trigger the probe with my ruler then it goes up then down again for a second time, the LDC goes back to the main info screen and when it is slowly going down to sense the bed (or ruler in this case) …
    in New setup Z homing crashes into bed Comment by opy01 April 2018
  • Ok while moving my z axis, I found that when I put a metal ruler under the probe, the min endstop still says off.  I'll disable the bed leveling stuff and see if I can get the endstop part working. Edit: Homeing works perfect without z-probing enab…
    in New setup Z homing crashes into bed Comment by opy01 April 2018
  • There was nothing in the eeprom as this is a new flash and nothing has been set.  Everything having to do with Z in the EEPROM is 0. I also did a load f EEPROM. I just tried autobedlevel and it did the exact same thing.  The z came down till the p…
    in New setup Z homing crashes into bed Comment by opy01 April 2018
  • I did not notice that you can switch to production 1.0.1.  That seems to be working so far.  Now to get my bed level sensor working.
    in 1.0.2 not working on my Mega 2560 and RAMPS. Comment by opy01 April 2018