muzzlitebeer
About
- Username
- muzzlitebeer
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
I'm trying to follow the instructions you directed me to in the manual, but when I upload my printer.cfg file, the 'Create Printer' button is inoperable, sort of greyed out. https://muzza.net/images/Repetier/Rep%205.jpg
-
https://muzza.net/images/Repetier/Rep 1.jpg https://muzza.net/images/Repetier/Rep 2.jpg https://muzza.net/images/Repetier/Rep 3.jpg https://muzza.net/images/Repetier/Rep 4.jpg
-
"You can not say klipper was already installed with fluidd on printer" What I meant was, I flashed Klipper onto the printer using my FluidPi installation. Fluidd created the firmware.bin file that I flashed the printer with. "First make sure you …
-
Well, it looks like it accepted /dev/tty0 this time! But the printer in 'Dashboard' keeps disconnecting and going red. This is what the console is telling me; Mesg:2:44:45.765: Connection startedMesg:2:44:45.765: Printer reset requested falseMesg…
-
Oh. I didn't realise I could type in that box. Thank you. So, if I'm reading you correctly, if I type in /tmp/printer and it doesn't connect, then I should try typing /var/lib/klipper?
-
Thank you. The repetierserver.local link didn't work, but I went into my router and found its IP address. It connected immediately! (I hope it doesn't keep changing...) It was always such a chore and a wait to get the wifi connection happening. …
-
Yes. I did the original installation in Marlin, then changed to Klipper. I was able to easily change the eeprom settings in the Klipper part of Octoprint. When I went across to Repetier, I couldn't find any information on using Klipper with Repeti…
-
OOps. Problem solved. The Pi wasn't connecting to the network. I had to reboot it. Now everything is sweet. Cheers.