moelski
* rebuild my Prusa I3 with repetier Firmware
* build a new Sparkcube XL
* get all running with a Raspberry Pi
About
- Username
- moelski
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Ok got it ... There was a start Script within my Repetier Code. After removing that all works fine. Domninik
-
Hier are some additional information: > 7:14:39.403: start > 7:14:39.404: Info:Watchdog Reset > 7:14:39.404: Transformation matrix: 1.000000 0.000000 0.000000 0.000000 > 1.000000 0.000000 0.000000 0.000000 1.000000
-
Hi ! I checked it and Ping Pong is disabled. And setting the Cache values higher didn´t change something. I did a Test with "M111 S24"In one second my Printer receives / consumes ~350 lines of GCode. Don´t know if this value is ok? Now I made a …
-
Hi !I will try your suggestions this evening. ping pong is set in server printer settings general tab. I can set PingPong only in Repetier-Host or is it available in the webserver version, too? but most delay is from latency during usb->serial c…
-
One additional question ... Would it help to use higher baud rates? Actually I use 115200. Maybe I should give 230400 a try?
-
Hi ! what speed are you using? It´s not that fast ... First try was 55mm/s and now 80mm/s. Now I have tested with #define PRINTLINE_CACHE_SIZE 80 #define MOVE_CACHE_LOW 30 But I still get interruptions. Make sure pin pong mode in connectio…
-
Hi ! I checked that double times ... I printed now 4 cubes ... 15*15mm and different in height. 5mm, 10mm, 15mm, 20mm. All of them are about 0,25mm to tall. There is no linear Addition in height. So I got 5.25mm, 10.28mm, 15.28mm and 20.23mm. I wo…