malcinator

About

Username
malcinator
Joined
Visits
9
Last Active
Roles
Member

Comments

  • Let apologise if I'm coming across as argumentative, not my intention at all. I just have experienced an issue and I'm only trying to find out why and what could be done to resolve it. I'm most definitely not trying to pick fault at your software, w…
  • Thanks for that information. I traced my problem back to this /usr/local/Repetier-Setup/templates/usb-mount.service. What was happening and I'll try to explain... I have my HDD's as sda sdb sdc sdd and each has a partition which I have been mountin…
  • Just to add a little more to this... When I mount my HDD sda1 to /mnt/disk1 the usb-mount.service scripts also then mount the same hdd to /media/flash, the same applies to sdb1 > /media/flash2 and sdc1 > /media/flash3. This as I understand i…
  • The drives are mounted using UUID and sda1 is where I have my symlinked Repeater-Server folder. If I list all devices ls -l /dev/disk/by-id I can see that my two SKR boards are sda and sdb. 
  • I have found the count now. I need to spend more time with Server and tweaking my workflow I guess.
  • Yes it’s confusing alright. I thought the convenience of being able to upload and print was time saver. How and where can I increase that count and what is it’s maximum limit? I feel that upload and print would work better for me than upload, open b…
  • I have run a coupe of prints this morning and the 'Upload' (from PrusaSlicer) adds the Gcode file to which ever group I choose. Then printing the file does not remove it from that group. The opposite is true for the 'Upload and Print' from PrusaSlic…
  • In prusa slicer I am presented with two choices, upload and upload and print. I also have a drop down list populated with my groups. I can choose which group to upload to. If I understand your answer above upload and print just put the file in…
  • I upload a gcode file to any group. I then print it as normal but on completion of the print the gcode file has been deleted. I can then no longer view or find the gcode file. I can see from the history that it’s been printed but the gcode file is n…
  • Hey, I have been using the 'Upload and Print' mainly. I have noticed that my backups are not increasing in size by much which and lead me down this rabbit hole. I have my Repeater-Server folder stored on an ext. SATA Hat (sda1) which is mounted at …
  • I'd really like to see this in some form too. Or perhaps integration with some other messaging app. I used Telegram from my Octoprint installs sometime ago and that worked really well.
  • Thanks, I'll download and install the deb file.
  • I'm using the lates 0.92.1 I do have zhop enabled as I'm using prusaslicer with my two i3's. Please don't ask me to disable it...
  • Perhaps a better use would be to send a notification via the informer app that the printer has run out of filament?
  • I feel this much more efficient that using the two clicks required to get there now? I I want to go to the printer I can follow the clearly labeled link below the webcam view. Or perhaps you could add a button adjacent to the go to printer button?