elidor
About
- Username
- elidor
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
Hello i was looking around , where can i find a tutorial for repetier linear adv ?
-
Hi yes 2 years i know , i guess for other new user .... my system powered with 24 volt , my fan is 12 volt 25 x 25 x 10 mm . i have added to my setup io PWM card , and then the fan could on do on or off . changed the fan control to PWM . problem …
-
Thank you
-
Hi again is there a way to disable only bed decouple ?
-
Hi roko yes i know this issue , i can work with 5 deg daviation on my prints , the thing is that i didnt print for along time and i just was trying to disable DAC by setting it to 0 in order to debug , but it didnt solve it so i was confused abo…
-
thank you the deviation is not more then 8 deg so 20 will work fine i guess . so why when i was setting DEC to 0 which is disable , still trigger the dec feature ? so i could adjust the fan ? by this Heater PWM speed >> 15HZ >> 30HZ &…
-
Ok i got somthing disabling DAC didnt help , im still getting the massage and the result of that . (extruder decoupled ) now... when im not using the fan , the printer didnt stop to print all the way . which is good for now but when the fan kicki…
-
Hello ronald latly i have the same problem that some users have here sins im using a fan , when the fans turns on the extruder temp going down alittle which im fine with that . but the system decoupled the extruder . i was looking at the graph…
-
ok i got it so i cant use . i can use only numbers , so how i configure 2.5 us sec ? can i configure in nano sec ?
-
Hello roland im using a bigger driver for a printer with a 2.5 delay and 5 us direction delay when im trying to change STEPPER_HIGH_DELAY to 2.5 us im getting a complie error there is no problem changing direction delay im getting this mass…