elidor

About

Username
elidor
Joined
Visits
10
Last Active
Roles
Member

Comments

  • Hello  i was looking around , where can i find a tutorial for repetier linear adv ?
  • Hi yes 2 years i know , i guess for other new user .... my system powered with 24 volt , my fan is 12 volt  25 x 25 x 10 mm . i have added to my setup io PWM card , and then the fan could on do on or off . changed the fan control to PWM .  problem …
  • Thank you 
  • Hi again  is there a way to disable only bed decouple ?
  • Hi roko  yes i know this issue , i can work with 5 deg daviation on my prints  , the thing is that i didnt print for along time and  i just was trying to disable DAC by setting it to 0 in order to debug , but it didnt solve it so i was confused abo…
  • thank you  the deviation is not more then 8 deg so 20 will work fine i guess . so why when i was setting DEC to 0 which is disable , still trigger  the dec feature ? so i could adjust the fan ? by this Heater PWM speed >> 15HZ >> 30HZ &…
  • Ok i got somthing disabling DAC didnt help , im still getting the massage and the result of that . (extruder decoupled ) now... when im not using the fan , the printer didnt stop to print all the way . which is good for now  but when the fan kicki…
  • Hello ronald  latly i have the same problem that some users have here  sins im using a fan  ,  when the fans turns on the extruder temp going down alittle  which im fine with that . but the system decoupled the extruder . i was looking at the graph…
  • ok i got it so i cant use .  i can use only numbers , so how i configure 2.5 us sec ? can i configure in nano sec ?
  • Hello roland im using a bigger driver for a printer with a 2.5 delay and 5 us direction delay  when im trying to change  STEPPER_HIGH_DELAY  to 2.5 us   im getting a complie error there is no problem changing direction delay  im getting this mass…