diasrs
About
- Username
- diasrs
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
It's the wrong steps per mm of what? the axis motor or the extruder? I used the Repetier-Firmware configuration tool to configure my firmware. Do I have to change it and send it again to my board? The PLA and the ABS looks like the same problem.. d…
-
I calculated the resolution, but it might be it, I'm going to recalculate.Flow is at 100%, I'm printing at 40mm/s at 210 ºC with PLA and 250 with ABS.Gonna make the changes, thank you.
-
It worked at homing... When I tried to print, the extruder came back to be 2.3mm higher than the table. What should I do?
-
MartinH said: #define Z_PROBE_HEIGHT 0 This line sets the distance from the bed to the nozzle when the probe triggers, in your case it should be set to 2.3 Then when you home Z and send a G1 Z0 the nozzle should just touch the bed. So you do…
-
Nice, I'm gonna try it! Thanks
-
Thanks for the help. I'll wait to see if someone can help me too!
-
I'm gonna change it, thanks. Now it'll check both endstops at homing? is that it? Yes, I read, and I did my best to configure it properly. I confess that I'm not a pro, and I have my doubts...I did the mapping of my table once using the z probe an…
-
Well, it doesn't go lower because it triggers the endstop.. One thing that I saw is that the maximum endstop doesnt work. It tries to go further, even with the endstops turned on. I made it home to the Zmin, because it didn't stop when the probe was…
-
I'm gonna try it in a few minutes and then I post the results
-
I hope it helps: /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation,…
-
Yes.
-
The nozzle is about one mm lower than the z probe. But the problem is still there.
-
Thanks, that solved my problem. I had never changed my din eeprom since the first program sent.