crumb4life
About
- Username
- crumb4life
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
Repetier said: Add in manual additions the line#define FAST_COREXYZ and you are using the fast variant. This make sit use nonlinear computation instead so you need to adjust these by first selecting delta printer (to make them appear). You do…
-
Repetier said: You are using the slow core xy variant. There you have double I think the steps per mm from what you think would be right. In fast core xy variant it is 1:1 mapping. What does this mean "Slow Core xy variant?" How do I not…
-
So in marlin my Steps are 100 for my x and my y with all 3 jumpers in place on my ramps. And this works. With that same 100 in Repetier it is not even close. I have tried 160 and 320. 160 is the closet. Can someone tell me are these numbers not a 1 …
-
MartinH said: Did you run the clear eeprom sketch in arduino before uploading the repetier FW, you may have some values left over from the marlin FW Yes I did. I got the speed thing figured out. My EEPROM settings were not saving had t…