cooldutchies
About
- Username
- cooldutchies
- Joined
- Visits
- 80
- Last Active
- Roles
- Member
Comments
-
Print is starting at zero and grinding on bed but print log says its at first layer height. Is this a know fault or a problem with simplify3D?
-
It was the stepper high delay Thankyou
-
Where can i change the distance for the filament drive buttons, Printer settings or firmware??
-
I have the same pro licence key running on all 3 machines because i just copied the .img could that be causing the communication format error causing it to stop and start heaters and feeding during a print leaving big lines and missing layers?
-
Fault from 21st July as above communications fault still stops heaters and feeders even with Dev FW. If communications fault will running it without a network fix it? Any idea when V0.8 will be ready?
-
Prints still stopping even with Dev FW i have this on 3 machines. If i disconnect it from the network will that fix it until v 0.8?
-
what is @pause change filament?More info please
-
Testing 1.0.0Dev with my working uploaded config.h file.Machine functions working ok but can not start a print.Machine says "Preparing Print" then gone nothing..........................................................................................…
-
Everything else good but now stops printing 1/4 way through stops heating see errors below any idea? > 21:33:11.274: ok 48837< 21:33:11.275: N638667 G1 X14.448 Y26.522 E2.1469> 21:33:11.281: T:219.57 /220 B:50.09 /50 B@:0 @:227 T0:219.57 /2…
-
OK so no errors on LCD screen. All working now but if i stop a print the extruder and bed temp stay on, Should be set back to zero?
-
Heat manager 1 for extruders and heat manager 0 for bed. What heat manager do you recommend?
-
Heaters are all ok and showing temp
-
Just stops heating? > 12:01:49.107: wait< 12:01:49.817: N52 M105> 12:01:49.828: ok 52< 12:01:49.828: N53 M84< 12:01:49.829: N54 M140 S30> 12:01:49.829: T:37.69 /0 B:21.10 /0 B@:0 @:0 T0:37.69 /0 @0:0 T1:20.98 /0 @1:0< 12:01:49.8…
-
Still happening just hangs and sets temps to zero during printAny idea why? > 13:18:39.917: wait< 13:18:40.035: N76017 M105< 13:18:40.035: N76018 G90> 13:18:40.042: ok 10481< 13:18:40.042: N76019 M82> 13:18:40.042: T:102.26 /0 B:2…
-
I plugged in a pixel screen and found def error on my extruder happens around 120 degrees Ill have to check my temp settings in the firmware. RS needs to show def errorsor else it just sits there locked up and waiting while the temp drops
-
I plugged in a pixel screen and found def error on my extruder happens around 120 degrees Ill have to check my temp settings in the firmware. RS needs to show def errors.
-
Resets to zero when idle after 60 seconds.Yes delay while printing after stop command.Im using Repetier V092
-
There should also be a way to directly upload Gcode from the Pi3 without a network??