cdburgess

Comments

• So if I understand you correctly, does that mean that if I use the projects to store the gcode, there will be a pause before each print because it will need to rerender/analyze the gcode every time?

  in File Management Comment by cdburgess October 2018
• It doesn't move outside of print. So you could get pooling. Once it powers up it will raise and home, reheat, then resume printing.

  in Print from SD / Save to SD ... to keep all security features from 3d printer Comment by cdburgess June 2018
• One other thing. When I finally stop the print, the printer then says it's disconnected and I need to reactivate the printer from the interface. Once it connects, it starts moving the bed of the printer and the hot end and will grind the stepper mot…

  in Random Printer Disconnect Comment by cdburgess June 2018
• I ran into the same issue. I have an MK2 upgraded to the MK2s, I have an MK2s, and an MK3. The MK3 connects just fine. The other two, however, was having the issue described. It turns out the the 3.1.0 version of the firmware doesn't handle the M110…

  in No functionality possible after update Prusa i3 mk2s FIRMWARE 3.1.0 Comment by cdburgess January 2018