Twistedair
About
- Username
- Twistedair
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
OR it could be that like me you don't have a Melzi v2 with a "fake" ftdi chip at all you have a Melzi v1 8Mhz which they are dishonestly claiming to be v2 16Mhz boards. It IS POSSIBLE to upload Repetier Firmware 0.92.9 to this board using Arduino 1.…
-
I'm lost with all this crud about fake FTDI chips & sabotaged FTDI Drivers delivered through Windows Updates etc. If the Arduino IDE can Upload Repetier 0.92.9 Firmware surely that means the serial driver as installed, works to some degree. The …
-
I'm trying to upgrade my Tronxy X3A which has barely worked since I got it. Apparently FTDI sabotaged the Com Port Driver which was forcibly applied through Windows Updates even tho it clearly screwed millions of people's 3D printers. FTDI then 'bac…
-
Not just my machine headbutting the heated plate then...
-
I don't know if this has anything whatsoever to do with your issue but something I noticed recently when trying to configure the firmware for Repetier was that the Arduino report would refer to an error saying eg. "ABCDE was not set in this scope" b…
-
Weeks? Ive had my 3D printer since February and I still havent seen any software or combination of settings heat the hotend and drive the motor for the Extruder though I have just once seen that rotating using Replicatr G. I can get my heated bed to…