- Last Active
OR it could be that like me you don't have a Melzi v2 with a "fake" ftdi chip at all you have a Melzi v1 8Mhz which they are dishonestly claiming to be v2 16Mhz boards. It IS POSSIBLE to upload Repetier Firmware 0.92.9 to this board using Arduino 1.…
I'm lost with all this crud about fake FTDI chips & sabotaged FTDI Drivers delivered through Windows Updates etc. If the Arduino IDE can Upload Repetier 0.92.9 Firmware surely that means the serial driver as installed, works to some degree. The …
I'm trying to upgrade my Tronxy X3A which has barely worked since I got it. Apparently FTDI sabotaged the Com Port Driver which was forcibly applied through Windows Updates even tho it clearly screwed millions of people's 3D printers. FTDI then 'bac…
Not just my machine headbutting the heated plate then...
I don't know if this has anything whatsoever to do with your issue but something I noticed recently when trying to configure the firmware for Repetier was that the Arduino report would refer to an error saying eg. "ABCDE was not set in this scope" b…
Weeks? Ive had my 3D printer since February and I still havent seen any software or combination of settings heat the hotend and drive the motor for the Extruder though I have just once seen that rotating using Replicatr G. I can get my heated bed to…