Sungod3k
About
- Username
- Sungod3k
- Joined
- Visits
- 12
- Last Active
- Roles
- Member
Comments
-
never mind someone had swapped the motor cables. i was to concentrated on the endstops
-
Ahh that makes sense. I used the config tools because I couldnt find 0.92.4 anywhere else Github only has 0.91 can I get any 0.92 from another source?
-
Update. I made the radius a bit smaller and now its working again, with some checksum errors but were moving again.
-
Well I had it working for a bit just now, and I was configuring the z probe but now Im getting these insane moves again 03:42:41.853 : Warning:Invalid delta coordinate - move ignored x:-6400 y:4800 z:-47184
-
Aha, coating is already 0 and you mean V0.92.4 right? Ill check on the height setting next. Thanks for the fast answer.
-
I used an endstop and that works. Thanks for the infos
-
Any recommendations on which pin to use? I going to try an unsued endstop next
-
In the mean time I just went for it and treated digital pin 0 as already activated. I have the mosfet hooked up to 12V and the signal wire to pin 0. The fan is still always on no matter what temp I put in the firmware.