Stiofan
About
- Username
- Stiofan
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
The board has 'BT7200 v1.8.26 Ramps Plus' stamped on it. The mosfets are directly behind the power inputs for the bed, EXT0 & EXT1. The original kit was He3D K200, the details are here: https://3dprinteruniverse.com/products/he3d-k200-delta-3d-…
-
Thanks for your quick response. I have swapped the stepper driver for EXT1 with a new spare I have, but it made no difference to the motor response. When I swapped the slots I swapped the cable in EXT1 to the EXT0 slot and it worked correctly, but …
-
Prusa G-code viewer, which was installed when I upgraded PrusaSlicer to version 2.7.2, will generate a preview of a sliced model from a gcode file. I can use it to verify that the modifiers are applied correctly from Slic3r. It just adds another ste…
-
No worries, Prusaslic3r gcode viewer can reconstruct the gcode to provide a preview of the modified model.
-
Ahh, I'm just confused since it was on the forum that a member was advised to use this technique in slic3r to change infill density. So does that mean that if I load any amf file that host will generate a new amf? Why does host generate a new one?…
-
Thanks for your speedy response. You were correct, I had the host printer setting inverting the z control display, so I was misreading as a false positive. I followed your advice and inverted the x, y & z directions and then HOME went to the c…