Stiofan

Comments

• Prusa G-code viewer, which was installed when I upgraded PrusaSlicer to version 2.7.2, will generate a preview of a sliced model from a gcode file. I can use it to verify that the modifiers are applied correctly from Slic3r. It just adds another ste…

  in Amf with modifiers not previewing properly in host. Comment by Stiofan March 18
• No worries, Prusaslic3r gcode viewer can reconstruct the gcode to provide a preview of the modified model.

  in Amf with modifiers not previewing properly in host. Comment by Stiofan March 17
• Ahh, I'm just confused since it was on the forum that a member was advised to use this technique in slic3r to change infill density. So does that mean that if I load any amf file that host will generate a new amf? Why does host generate a new one?…

  in Amf with modifiers not previewing properly in host. Comment by Stiofan March 16
• Thanks for your speedy response. You were correct, I had the host printer setting inverting the z control display, so I was misreading as a false positive. I followed your advice and inverted the x, y & z directions and then HOME went to the c…

  in Home travelling in wrong direction regardless of Z_HOME_DIR Comment by Stiofan November 2021