Speedi1
just a noob who tries
About
- Username
- Speedi1
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
null Thank you
-
Yesterday I counted a certain number of steps and measured the distance, calculated how many steps per mm and entered it, but did not seem to make it work. Is 5 by pressing the arrow in the host program, 5 mm or 50 mm?
-
Was in the process of measuring step per mm, which did not seem to work as expected. Set Z down to 1/8 and step per mm on all asix to standard 80, seemed to work, but needed to quit, so did not get measured.. In the first attempt, Y moved about 5mm…
-
Repetier said: With more microstepping all values go down. So from full to 1/16 acceleration/jerk/speed are all just 1/16 until you increase steps per mm again. Belt/rod have different steps/mm so what works on rod might be too much for belt …
-
Repetier said: With more microstepping all values go down. So from full to 1/16 acceleration/jerk/speed are all just 1/16 until you increase steps per mm again. Belt/rod have different steps/mm so what works on rod might be too much for belt …
-
MartinH said: What controller board do you have, are the micro step jumpers fitted Repetier said: If motors make sound without moving you are hearing the steps lost. Reasons: - microsteps not selected as you thought - Steps per mm…
-
null Is first at it tomorrow but will start putting jumpers in, after this I will try out some of the possible things you write. Not setup with jerk.
-
null Sorry, Mega 2560 and ramps 1.4, no jumpers yet