Rismyhr

About

Username
Rismyhr
Joined
Visits
0
Last Active
Roles
Member

Comments

  • Thanks again! I can cut superslow with v.1.0. I dont know i understud xy jerk max. If I print in 80mm/min i need to set the jerk higher than 1.4mm/sec?
  • Okey. Thanks! on my firmware i run 0.92.9 i think. Is there a version 2 to try. I see there is v.1.0.0 dev. 
  • Repetier said: Did you already try 1.0 version? I think there you can set a lower minimum speed now. Problem is that the acceleration algorithm needs a minimum speed for stability. So you should set xy jerk higher then your minimum speed. In…