OkurRo

Comments

• Well you could send it from min to max and let it measure distance, but that would need a new command since it only stops, but continues counting when hit max end. And if you would do this after you calibrate it the conventional way, you would get t…

  in Auto steps/mm correction Comment by OkurRo December 2017
• I know solution with calibration cubes, but I think that many people would invest a few dollars into max endstops if this would be a thing. And it could help to get these calibrations less time consuming and less material consuming, beacuse of bigge…

  in Auto steps/mm correction Comment by OkurRo December 2017
• And in setting for jam detection and out of filament detection, i should leave the preset numbers for regular steps per cycle, slowdown steps, slowdown to... Or should I fill in 0 everywhere?

  in Filament out sensor Comment by OkurRo December 2017
• I can see there: #if SDSS > -1#if SDCARDDETECT > -1 Is that correct? I am using Mega 2560 clone, RAMPS 1.4 and reprap discount full graphic smart controller

  in SD init fail Comment by OkurRo July 2017
• i have tried changing sd reading to sixteenth and waiting for init to 1000 miliseconds but still the same

  in SD init fail Comment by OkurRo July 2017
• I can't upload programs to that arduino, but when I connect display I can controll the printer with it, so only problem is comunication with PCs.

  in communication timeout after powering up Comment by OkurRo October 2016
• It was, there was only problem with isolation could it be it?, yes it persist

  in communication timeout after powering up Comment by OkurRo October 2016