› ›

Kyuga

About

Username
Kyuga
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Repetier said: Hub of course also uses a bit of power. If you have no components using power a passive one is enough. If you add other devices like webcam that also use power it depends on how much they use and how good the pi power supply is…
    in All printer disconnection Comment by Kyuga July 2020
  • RAyWB said: Raspberry is well known for power sensitivity.1st as power sensitive itself2nd limited usb output power. you can solve the problem by external powered usb hub or by cutting respectively masking the +5V connectionin usb connection …
    in All printer disconnection Comment by Kyuga July 2020
  • Kyuga said: It has happened to me a couple of times that the 4 printers that I have connected stop and I lose all my jobs. This happened after I turned off one of the printers to restart it while the others were working. Despite having turne…
    in All printer disconnection Comment by Kyuga July 2020
  • So, I flashed the firmware with the option you told me: #define RX_BUFFER_SIZE 128 Then I went to pronterface, connect to the printer and M502  M500 (is this ok?) Now I configure it with a buffer of 127 in repetier server. But the only way to conn…
    in Printer only connects with 46 input buffer Comment by Kyuga July 2020
  • Repetier said: In configuration_adv.h you have // Host Receive Buffer Size// Without XON/XOFF flow control (see SERIAL_XON_XOFF below) 32 bytes should be enough.// To use flow control, set this buffer size to at least 1024 bytes.// :[0, 2, 4…
    in Printer only connects with 46 input buffer Comment by Kyuga July 2020
  • First of all I thank you for the quick response. Much appreciated. If you put a value greater than 46bytes, it directly did not connect. It said to check the baudrate and the firmware. I am using Marlin 1.8.0.3. The printer is a clone of the Geeet…
    in Printer only connects with 46 input buffer Comment by Kyuga July 2020