HRIM
About
- Username
- HRIM
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
Hello, thank you for your reply. This is what shows on the repetier host: 11:23:52.868 : ENGINE~1.GCO 833872711:23:52.868 : End file list11:23:52.883 : X:160.00 Y:230.00 Z:0.25 E:0.00 Count A:62400B:-11200 Z:400011:23:52.899 : X:160.00 Y:230.00 Z…
-
Okey. Thank you.
-
I wanted to use REPETIER. But I can't find MKS GEN L V2.1... Could u show me how? Thank u
-
Any help please from your side would be appreciated a lot. I've tried evrything I found in the net , but it seems like I still have an issue that I don't know where.. Thank you. Regards,
-
RAMPS.H //// Servos//#ifndef SERVO0_PIN #ifdef IS_RAMPS_13 #define SERVO0_PIN 7 #else #define SERVO0_PIN 11 #endif#endif#ifndef SERVO1_PIN #define SERVO1_PIN 6#endi…
-
//=============================================================================//============================= Additional Features ===========================//============================================================================= // @sectio…
-
//=============================================================================//============================== Movement Settings ============================//=============================================================================// @section…
-
#ifndef MOTHERBOARD #define MOTHERBOARD BOARD_MKS_GEN_L_V21 #endif */#define SERIAL_PORT 0 /** * Serial Port Baud Rate */#define BAUDRATE 115200//#define BAUD_RATE_GCODE // Enable G-code M575 to set the baud rate /** * Select a secondary seri…