George_P
About
- Username
- George_P
- Joined
- Visits
- 56
- Last Active
- Roles
- Member
Comments
-
No, Dry run was carefully switched off, and even enable pin on RAMPs stayed on +5V all the time.On other motors with the same setting of enable pin it was 0.I had installed the 0.92 firmware version all the time but cold run was not working. But eve…
-
HI Repetier, I am facing the same problem as my predecessors.Everything works with Marlin 1.0.0 running on Arduino 2560 with RAMPs and Repetier host 1.0.6.With Repetier firmware 0.92 on that hardware only XYZ movements and heaters works.M302 S0 comm…
-
Hi Brian, why do you have all pins connected to E1 pins instead of E0 ?(ORIG_E1_STEP_PIN instead of ORIG_E0_STEP_PIN etc.)George