› ›

George_P

About

Username
George_P
Joined
Visits
56
Last Active
Roles
Member

Comments

  • No, Dry run was carefully switched off, and even enable pin on RAMPs stayed on +5V all the time.On other motors with the same setting of enable pin it was 0.I had installed the 0.92 firmware version all the time but cold run was not working. But eve…
    in Extruder motor won't go Comment by George_P October 2014
  • HI Repetier, I am facing the same problem as my predecessors.Everything works with Marlin 1.0.0 running on Arduino 2560 with RAMPs and Repetier host 1.0.6.With Repetier firmware 0.92 on that hardware only XYZ movements and heaters works.M302 S0 comm…
    in Extruder motor won't go Comment by George_P October 2014
  • Hi Brian, why do you have all pins connected to E1 pins instead of E0 ?(ORIG_E1_STEP_PIN instead of  ORIG_E0_STEP_PIN  etc.)George
    in Extruder motor won't go Comment by George_P October 2014