› ›

Fakue

About

Username
Fakue
Joined
Visits
2
Last Active
Roles
Member

Comments

  • I don't have any endstops at all... So this is the response from the firmware.
    in ABC Axis movement Comment by Fakue March 2020
  • Ah M119 says Endstop hit: so no endstop is triggered...
    in ABC Axis movement Comment by Fakue March 2020
  • Hey, strange times right now... other things get prio the last weeks... now i´m back working a bit... I got managed to move XYZAC Axis except B Axis. If i try to move the B Axis during Move Menue in GUI nothing happens, after trying this also all o…
    in ABC Axis movement Comment by Fakue March 2020
  • Don´t ask me why but that was the needed hint! #define RFSERIAL Serial and #define BLUETOOTH_SERIAL 101 was set already so i tied to use the Native USB Port at the Due. This worked! So now, still the Programmer Port just work for Uploading but the N…
    in dev v2 connection issue Comment by Fakue March 2020
  • Tried the EEPROM_MODE change without luck. Baudrate is 115200 in the configuration.h in config meun and in Pronterface. I´m using the programmer Port at the Due. Does Repetier allow to change to the Native Port? Will try next week to start from zero…
    in dev v2 connection issue Comment by Fakue March 2020
  • Thanks. I will try the EEPROM_MODE change!  Yes the display works fine, also the encoder and the reset button. Didn´t tried the SD Card so far. In menu all six axis are showing up and are configurable. Du to no use of a tool i don´t need a extruder …
    in dev v2 connection issue Comment by Fakue March 2020