Fakue
About
- Username
- Fakue
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I don't have any endstops at all... So this is the response from the firmware.
-
Ah M119 says Endstop hit: so no endstop is triggered...
-
Hey, strange times right now... other things get prio the last weeks... now i´m back working a bit... I got managed to move XYZAC Axis except B Axis. If i try to move the B Axis during Move Menue in GUI nothing happens, after trying this also all o…
-
Don´t ask me why but that was the needed hint! #define RFSERIAL Serial and #define BLUETOOTH_SERIAL 101 was set already so i tied to use the Native USB Port at the Due. This worked! So now, still the Programmer Port just work for Uploading but the N…
-
Tried the EEPROM_MODE change without luck. Baudrate is 115200 in the configuration.h in config meun and in Pronterface. I´m using the programmer Port at the Due. Does Repetier allow to change to the Native Port? Will try next week to start from zero…
-
Thanks. I will try the EEPROM_MODE change! Yes the display works fine, also the encoder and the reset button. Didn´t tried the SD Card so far. In menu all six axis are showing up and are configurable. Du to no use of a tool i don´t need a extruder …