Deltaman
About
- Username
- Deltaman
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
The problem was hardware... I just didn't realize the problem before
-
BTW the development version was not current it was older
-
Thank you... It worked
-
Ok will try it thank you very much. I really like how easy it is to setup repetier firmware as apposed to marlin, sprinter or others. You did a great job with the configuration tool and the host program. (I haven't tried the server) I was stuck usin…
-
so do I still do this part? /* Z-Probing */#define FEATURE_Z_PROBE true #define Z_PROBE_PIN 63 #define Z_PROBE_PULLUP true #define Z_PROBE_ON_HIGH true #define Z_PROBE_X_OFFSET -11.2625 #define Z_PROBE_Y_OFFSET -6.5 // Waits for a signal to start. V…
-
I believe that I did. I have tried using the web configurator and manually adding the lines in. Both times I had no success. This is where I should look for the info right? https://www.repetier.com/documentation/repetier-firmware/z-probing/ I added …
-
Ok, I gave a bad example, but any leveling based commands will say "Unknown Command" in the console. Even when i say G31 I get unknown commands in the console.