Cyrusfxx

Comments

• Thank you so much for your help. I uploaded EEPROM_CLEAR then upload Repetier firmware. Everthing is as expected. Thanks again

  in After following the steps on Z-probe, can't compile and upload Comment by Cyrusfxx June 2015
• Thanks for replying. I manage to solve the problem. I am using Ramp board 1.4. I change my Z_probe pin from 63 to 18. Plus I update the Arduino from 1.6.4 to 1.6.5. Seems to work properly now. But I key G32 to do auto leveling. This happen Warning…

  in After following the steps on Z-probe, can't compile and upload Comment by Cyrusfxx June 2015