› ›

CrisCG

About

Username
CrisCG
Joined
Visits
6
Last Active
Roles
Member

Comments

  • Looks like it started working after i reduced the printing segment/s from 180 to 100. I printed for almost 3 years with 180 and didn't had any problems. I don't understand why it would be a problem now. But it work with the new 100 segments/s settin…
    in Delta printer stopping shortly after print start Comment by CrisCG May 2019
  • it just gives a wait message per second, so it's not followed by a start. I replaced the PSU, then RAMPS 1.4 and now the arduino mega... and it's the same. Silly bug.
    in Delta printer stopping shortly after print start Comment by CrisCG May 2019
  • I just installed a new PSU and it does the same thing. So much for that, i guess it's the either the arduino or the RAMPS. What do you think?
    in Delta printer stopping shortly after print start Comment by CrisCG April 2019
  • Now i have another strange problem. When adjust endstops, i adjust with the value i measure using the paper test, then home it, come back again to the same position and everything is the same. Sometimes it does adjust, sometimes it ignores the value…
    in Motors disabled after movement Comment by CrisCG February 2016
  • Thank you for your reply. I did check those settings and they were correct. But the problem dissapeard after reuploading the firmware and reseted EEPROM settings. Must have been something left-over from Marlin, although i did reset the EEPROM to def…
    in Motors disabled after movement Comment by CrisCG February 2016