CrisCG

About

Username
CrisCG
Joined
Visits
6
Last Active
Roles
Member

Comments

  • Looks like it started working after i reduced the printing segment/s from 180 to 100. I printed for almost 3 years with 180 and didn't had any problems. I don't understand why it would be a problem now. But it work with the new 100 segments/s settin…
  • it just gives a wait message per second, so it's not followed by a start. I replaced the PSU, then RAMPS 1.4 and now the arduino mega... and it's the same. Silly bug.
  • I just installed a new PSU and it does the same thing. So much for that, i guess it's the either the arduino or the RAMPS. What do you think?
  • Now i have another strange problem. When adjust endstops, i adjust with the value i measure using the paper test, then home it, come back again to the same position and everything is the same. Sometimes it does adjust, sometimes it ignores the value…
  • Thank you for your reply. I did check those settings and they were correct. But the problem dissapeard after reuploading the firmware and reseted EEPROM settings. Must have been something left-over from Marlin, although i did reset the EEPROM to def…