AMB
About
- Username
- AMB
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Hi Repetier! I still cannot find any solution. Please help.
-
G28: Worked well G1 Z10: Worked, but the distance between probe and bed was 6mm, and not 10 mm. G30 P1: Hit one point near origin and stopped My point was, as you said, move the probe to find limits. I couldn't move the probe. Log s…
-
Yes. It also looked simple to me. But the motors were locked after this step, and I couldn't move the probe, until I used M84 command. After this, when I touched the bed, I got no response, and the Bl Touch sensor red LED started blinking. Also, th…
-
Ok. Its hitting those coordinates I think. I want to find out border coordinates. I checked with following 150, 0 It hit border 0, 150 aprox 5mm out of border 0, -150 approx 15 mm inside border When the first coordinate hits the border, then…
-
I used G32 S2 with following values; (-69.28,-40), (69.28,-40), (0,80) z probe points and it hit the coordinates near to origin. How to add error in these settings? Still confused as how to verify them. My printer has 165 mm printable radius, 5…
-
Repetier said: The rectangle you see is a preview sample for printer. You have enabled it in printer settings->shape and should disable it. Makes no sense to show a shape not matching printer. OK. Anyways, thanks for support. Till now, …
-
Done it. Edited Z probe X1,Y1, X2, Y2 & X3, Y3, and it worked
-
i have got Repetier-Host V2.1.3 version. I couldn't find P1, P2, P3 fields there. I checked in firmware eeprom configuration. The rectangle is as shown in image.
-
Repetier said: You need to consider that activating z probe adds the offset. So select a rectangle inside your bed that is allowed including offset. Or do a simple 3 point bed levelling always close to the 3 columns but within limits of allow…