dhyre
About
- Username
- dhyre
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
I just had this happen to me! First time ever. Caused a head-crash because the Z-height got set +50 longer than it had been for months. I had done a "kill print" on a job I ran last night, then started up this morning and was alerted by the sound of…
-
In my case, it turns out the printer supplier (Boots) is only offering 0.91 and they haven't upgraded yet. Is there anything other than the boot-up logo that would prevent me using 0.92 directly from you?
-
Heat the hotend to 155 and see if it works - there is an embedded safety parameter for minimum extrusion temperature, not just having the hotend on, but above 150. That made mine work immediately. They stopped working as soon as the temp dropped bel…
-
Same here. I can move my 2 extruders from the LCD control panel, but not from Repetier. I've checked steps/mm, it's at 300 for both; other parameters seem reasonable too. The hot end is at temperature and Repetier knows this. I've even tried setting…