› ›

mchotti

About

Username
mchotti
Joined
Visits
5
Last Active
Roles
Member

Comments

  • Meiner Erfahrung nach - ich habe bei dem Projekt mitgewirkt - gibt es einen grundlegenden Unterschied zwischen X1C und P1* .. der X1C reden viel und die P1* müssen gefragt werden. In dem Code sieht man dazu einen "Schalter", der beim P1* einfach ein…
    in Bambulab Drucker Comment by mchotti April 20
  • Vielleicht hilft auch diese Arbeit ein wenig: DrozmotiX/ioBroker.bambulab: This adapter integrates Bambulab 3D-Printers into ioBroker. (github.com) Wie ist der Stand bei der Integration?
    in Bambulab Drucker Comment by mchotti April 20
  • Ich würde es super gern sehen, wenn der Bambulab im Repetier integriert wird. Repetier ist meine bevorzugte Farmverwaltung und daran würde ich ungern etwas ändern. Allerdings verstehe ich den Unterschied in der Kommunikation und als Entwickler kenne…
    in Bambulab Drucker Comment by mchotti August 2023
  • After the update - great job by the way - I see this information. But this not possible to be shown in the table of gcodes in the project? Okay .. better than nothing an I just need this information only when the spool isn´t full.
    in Show the filament length of an gcode file Comment by mchotti March 2023
  • Yes .. it´s send every 5-10 minutes if the weight has changed. But this is easier for me to implement, because the ESP Modules doen´t need to be reachable from the repetier. 
    in Spool Weight Display Comment by mchotti January 2023
  • Thank you. I´ll try this way and the delay can be an hour .. now the farm is running multiple hours without printing and so I can just save a little bit of energy and gently shutdown the farm.
    in Shutdown and GET-Request after all jobs are done Comment by mchotti January 2023
  • Thank´s .. It´s one possible way and has to be configured per printer .. but I´ve one more question.  The ESP weight scale can send the information of the weight to an endpoint in repetier and then it can be used for an computed expression? Or do I…
    in Spool Weight Display Comment by mchotti January 2023
  • I can run an own service which uses the "listPrinter" endpoint and if all jobs are "none" request the switch off. Is there a way to do this inside?
    in Shutdown and GET-Request after all jobs are done Comment by mchotti January 2023
  • The only solution right now is to manipulate the "name" of the printer like "P1 - 0.6 - PETG-JB - 127m"
    in Spool Weight Display Comment by mchotti January 2023