simonlight001

About

Yes set that in the firmware of the printer. Doing as followed, the M114 changed by 25 each time, the actual printer moved by 25, then around 10, then nothing on the last command. Checked M119 at each stage and no change - all set to low

in Z axis wont go any higher than 36.8 Comment by simonlight001 May 2020
Tried just in case. I set the Max Z to 240 - previously it was set to 0 meaning no max. The exact same behaviour is happening

in Z axis wont go any higher than 36.8 Comment by simonlight001 May 2020
Hi Thanks for this, gave it a shot. The printer moved up but stopped at the same place as usual (36.8). when running M114 the printer thinks its at z 50 and so does Host. Does this suggest EEPROM settings?

in Z axis wont go any higher than 36.8 Comment by simonlight001 May 2020