jackomyers
About
- Username
- jackomyers
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Hi again, thank you for the assistance so far. I have an update, but it's not all good news, maybe you could help me figure this out because I'm clearly doing something wrong... I can get the filament sensor to trigger through jobs sent from Repet…
-
Thanks for the assist. I'll give that a try. Just to confirm the usage, did you include that in the slicer software precursory code or is that placed in the "Run Before Job" event dependency? Thanks J
-
Thanks for the response. I've been looking at the compiling software and there's a note that says the following: * Filament Runout Sensors * Mechanical or opto endstops are used to check for the presence of filament. * * IMPORTANT: Runout will onl…
-
Thank you very much for your speedy response, I will pass this information to my guy, I'm sure that documentation will make much more sense to him!