jkisinger
About
- Username
- jkisinger
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
It is so wierd that it always happens at the same x y coordinates but only when I allow Host to default print bed location. Of it were wiring I would think it would do it regardless. I'm going to install Host on a laptop and try a print and see wh…
-
You may find this interesting. I finally got a successful print. I thought it might have something to do with the print head location on the x y axis. So I moved the job on the bed in the Host software to avoid the x y coordinate where printing s…
-
This just happened mid print. The printer stopped at the point where the log shows "printer reset detected" It just stops printing. The head doesn't go home or anything. It just stops. I didn't do anything to reset it. It was happily laying dow…
-
Where would the printer reset detected command be generated? I was of serving the print and it didn't lose power to the printer. It probably wouldn't do that in the same place in the print job each time anyway. Should I reflash the firmware or do…
-