› ›

Romain34

About

Username
Romain34
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Ok , thank you
    in CNC Z probe Comment by Romain34 August 2018
  • Thank you Repetier for the reply When i'm using G30, Z goes down, when i trigger Z probe, Z returns to the position he had before the G30, and when i start the job, the job starts at the current position, not where the Z probe was triggered. I wou…
    in CNC Z probe Comment by Romain34 July 2018
  • Hi !I'm still at the same point Does anyone could help me please ?
    in CNC Z probe Comment by Romain34 July 2018
  • I tried with this configuration : #define Z_PROBE_Z_OFFSET 0 #define Z_PROBE_Z_OFFSET_MODE 0 #define UI_BED_COATING 1 #define FEATURE_Z_PROBE 1 #define EXTRUDER_IS_Z_PROBE 0 #define Z_PROBE_DISABLE_HEATERS 0 #define Z_PROBE_BED_DISTANCE 10 #define Z…
    in CNC Z probe Comment by Romain34 July 2018
  • Hi !I fixed the issue !The firmware was good, the issue was interferences in my cables that sent high signal !I wired the switch normaly closed and inverted the logic of the switch in the firmware and now all works perfectly
    in Problem with Z max Home Comment by Romain34 May 2018
  • // ##                              CNC configuration                                       ## /* If the firmware is in CNC mode, it can control a mill with M3/M4/M5. It works similar to laser mode, but mill keeps enabled during G0 moves and it allo…
    in Problem with Z max Home Comment by Romain34 May 2018
  • Hi Repetier ! Thank you for your reply, My Z direction is ok, when i click on the up arrow on Repetier Host, Z goes up, when i click on the down arrow, Z goes down !The CNC job is ok, my only issue is the Z home direction
    in Problem with Z max Home Comment by Romain34 May 2018