› ›

156801

About

Username
156801
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Will try calibration of the extruder.  
    in Print not sticking flow rate Comment by 156801 June 2018
  • I have been trying to install a BL Touch for awhile and almost there. However I did come across a few problems that I had to sort out. http://www.geeetech.com/wiki/index.php/3DTouch_Auto_Leveling_Sensor. If may help
    in Help. Calibrating Z-Probe? Comment by 156801 June 2018
  • I tried adjusting z acceleration and jerk but it did not work. I ended up adjusting the voltage on the driver and so far so good. I keep the z adjustment hoping for a better print quality.
    in Z axis start / stop Jerking? Comment by 156801 June 2018
  • Hi,new to 3d printing and worked my way through a few problem but have come across a new one.  All of a sudden both z motors have started to stop and start. This can happen when moving up or down. I would not say they are jerking as you can see in t…
    in Z axis start / stop Jerking? Comment by 156801 May 2018