Ott3rman
About
- Username
- Ott3rman
- Joined
- Visits
- 39
- Last Active
- Roles
- Member
Comments
-
Repetier said: Ok, that was a hard one. Reason is again the missing reset so a special condition was never fullfilled. In my develop version I have solved it, so next release should also connect to printrboard with marlin. Any news on when…
-
Here is a log from OCtoprint after having problems connecting. I ended up pressing connect/disconnect rapidly, and BANG it connected to Octoprint via PI Changing monitoring state from 'Connecting' to 'Offline'Connection closed, closing down monitor…
-
Windows 7 I know! It just do not make sense at all. I am "this" far away from a clean install of the server. But I really don't think that will fix it. Well, I'll keep using Repetier Server on a remote desktop for now, and hope You can get to the b…
-
Tested it out. I get answer in any combination with RTS and DTR pin. Here is a dump of the M503 command: ok N61401 P15 B15echo:Steps per unit:echo: M92 X93.00 Y93.00 Z1097.50 E97.00echo:Maximum feedrates (mm/s):echo: M203 X150.00 Y150.00 Z1.50 E50…
-
I must admit this sounds abit over my head, but as I understand you will try to make it work in a new version?
-
Sorry for the delayed answer. When I connect with Host there is no noticable delay or anything. It does not boot the printer as far as I can see. It seems it connects by just joining the conversation if you understand what I mean? Is there a command…
-
< 10:01:42.825: N1 M105< 10:01:43.831: N2 M105< 10:01:44.721: M110< 10:01:44.721: N2 M105< 10:01:44.721: N3 M115< 10:01:44.721: N4 M220 S100< 10:01:44.721: N5 M221 S100< 10:01:44.721: N6 G92 E0< 10:01:44.723: M117 IP:192.1…
-
I see, but my wonder is why it works like a charm in S3D, Cura and Repetier Host, but not Repetier Server? Is there something that can be done in a future update or something, as it seems to be a weakness of the software more than a problem with the…
-
Seems they actually TALK a little bit. I set it up like it should be with extruder etc. And when I set an extruder temp over and over again, it finally takes, and the printer heats up. So they talk a little bit it seems... The connection sumbol cha…
-
So here are the logs for the V1 that connects, and the V2 that does NOT connect: V1 That works:10:27:20.365 : No start signal detected - forcing start10:27:20.387 : N1 M110*3410:27:20.387 : N2 M115*3610:27:20.387 : N3 M105*3610:27:20.387 : N4 M114*3…
-
I have tried all this. And as said I can easily connect it to Repetier Host, Cura and Simplify3D. I just don't get why Repetier Server can't connect. It's sending data, but not recieving anything according to the stats. It seems it wait for some sor…