› ›

iCrash

About

Username
iCrash
Joined
Visits
7
Last Active
Roles
Member

Comments

  •  Repetier said: Using our server or host you can modify the value in eeprom at any time without reuploading firmware. Why would you not have an icon on the LCD display to set this?  This is a common issue I have with my printer too.  And h…
    in Proper way of adjusting Z offset from LCD when doing first layer? Comment by iCrash July 2022
  • I just tried to print a new file I just created.  It is still not doing the G32. Here is the beginning of the Gcode.  Most of this is what Ideamaker puts in for gcode.  The only thing I added was the G4 P1000 for a 1 second dwell and the G32 for aut…
    in Pi Server changing gcode Comment by iCrash September 2017
  • Ok, thank you for that information. I did make everything capital and put spaces for the XYZ coordinates.  The test code worked every time.   So, I guess this isn't a bug and more a matter of I didn't understand.     All is good, thanks for helpin…
    in Pi Server changing gcode Comment by iCrash September 2017
  • Hello, thanks for the reply.  I will try to run the code as you suggested later this afternoon. FYI, I run a CNC in my shop and it is not case sensitive for gcode and does not care if there are spaces on the xyz coordinates.  My CNC in my shop runs…
    in Pi Server changing gcode Comment by iCrash September 2017